Fortinet 548B - Page 450

- 450 -
Command Mode
Router OSPF Config Mode
8.3.2.10 area nssa no-summary
area nssa no-summary command configures the NSSA so that summary LSAs are not advertised into
the NSSA. no area nssa no-summary command disables nssa from the summary LSAs
Syntax
area <areaid> nssa no-summary
no area <areaid> nssa no-summary
Default Setting
None
Command Mode
Router OSPF Config Mode
8.3.2.11 area nssa translator-role
area nssa translator-role command configures the translator role of the NSSA. A value of always
causes the router to assume the role of the translator the instant it becomes a border router and a value
of candidate causes the router to participate in the translator election process when it attains border
router status. no area nssa translator-role command disables the nssa translator role from the
specified area id.
Syntax
area <areaid> nssa translator-role {always | candidate}
no area <areaid> nssa translator-role {always | candidate}
Default Setting
None
Command Mode
Router OSPF Config Mode
8.3.2.12 area nssa translator-stab-intv
area nssa translator-stab-intv command configures the translator <stabilityinterval> of the NSSA. The
<stabilityinterval> is the period of time that an elected translator continues to perform its duties after it
determines that its translator status has been deposed by another router. no area nssa