Fortinet FortiAP 234G - Waterproof Cabling; Cabling Procedure; Interfaces; LED Status Indicators

10 11
Waterproof Cabling
Your device comes with IP67 rated Ethernet cable glands.
1. Unscrew the sealing nut from the panel connector and remove the seal
and claw
2. Thread the RJ45 plug through the sealing nut, then the panel connector
3. Wrap the seal and claw around the cable between the sealing nut and
connector
4. Insert the RJ45 plug into the port and screw the panel connector onto
the threads
5. Slide the seal and claw along the cable into the panel connector
6. Threat the coupling ring onto the panel connector and tighten it
Sealing NutSeal and ClawPanel Connector
1 2 3 4
Interfaces
1
LED STATUS
Power
Green: Powered on; connected to a controller
Amber: Powered on; not connected to a controller
Off: Powered off
LAN
Green: Connected
Blinking Green: Data activity
Off: Not connected
WiFi
Green: SSID broadcasting
Blinking Green: Data activity
Off: WiFi not broadcasting
2
3
4
CONSOLE (RJ-45) CLI management; Reset button above port
LAN2 / PoE (RJ-45) 1 Gbps Ethernet interface
LAN1 / PoE (RJ-45) 2.5 Gbps 802.3at PoE Ethernet interface