Firewall Policy
FortiGate-60 Administration Guide 01-28006-0002-20041105 191
Policy list
You can add, delete, edit, re-order, enable, and disable policies in the policy list.
Figure 81: Sample policy list
The policy list has the following icons and features.
Figure 82: Move to options
Create new Select Create New to add a firewall policy.
ID The policy identifier. Policies are numbered in the order they are
added to the policy list.
Source The source address or address group to which the policy applies.
See “Address” on page 198.
Dest The destination address or address group to which the policy
applies. “Address” on page 198.
Schedule The schedule that controls when the policy should be active. See
“Schedule” on page 210.
Service The service to which the policy applies. See “Service” on
page 202.
Action The response to make when the policy matches a connection
attempt.
Enable Enable or disable the policy. Enabling the policy makes it
available for the firewall to match it to incoming connections.
source -> destination (n) Policy list headings indicating the traffic to which the policy
applies. The list heading is in the format Source -> Destination (n)
where n is the number of policies in the list.
The Delete and Edit/View icons.
The Insert Policy before icon. Add a new policy above the
corresponding policy (the New Policy screen appears).
The Move to icon. Move the corresponding policy before or after
another policy in the list.
To Next Page
Loading...
