18
help
Show a list of valid CLI commands.
show
Show the bootstrap configuration including
the port IP address (IPv4), network
mask, and default gateway.
set port1-ip <ip>/<netmask>
Set the port 1 IP address and netmask.
set portX-ip <ip>/<netmask>
Set the port X IP address and netmask.
set default-gw <ip>
Set the default gateway.
reboot
Reboot the FortiSandbox. All sessions will
be terminated.
shutdown
Shut down the FortiSandbox.
status
Show various system information.
For example, to configure the IP address and gateway of the FortiSandbox device, use
the following commands:
set port1-ip 192.168.0.10/24
set default-gw 192.168.0.1
Useful CLI Commands
A limited CLI is available for basic device configuration and debugging purposes.
The FortiSandbox device is primarily configured using the GUI.
To Next Page
Loading...
