98
Adapter Bracket
1
3
2
Place device to one side of the tray above the tray magnets.
Place the device onto the adapter bracket which uses magnets to
secure the device.
Note: The Kensington security slot on the device is not available when
the device is installed in the adapter bracket
Before you begin, power off and disconnect the device. If applicable,
remove the four 4mm M3 screws from the sides of the device. Note, the
Optional: If applicable, secure the device sides to the bracket using four
6mm M3 flathead screws or use up to two screws to secure the bottom
4
Attach provided grounding wire from the back of the device to the rack
mount using a 6mm M3 panhead screw.
Optional: Secure the device bottom with 6mm M3 flathead screws
2 Screws
1 Screw
To Next Page
Loading...