31
7.7.6. Chase Mode
You can switch the Cue-lists playback between Cue-lists mode or chase mode by pressing [Chase Mode].
7.7.7. Flash Mode
The function is only used for key-playbacks. The playback key will be used as a flash when you open the function.
7.7.8. Rename the Playback
Select a playback in the list can rename the playback by option [Playback Legend].
The name of the playback will be shown at the bottom of the screen. You can press the [Func] key to switch display
the key-playback name or attribute name on the screen.
7.7.9. Release Mode
You can set the release mode for playback as follow:
[Freeze All Attribute] ---- All attribute channels will be held except HTP channel;
[Release All Attribute] ---- Resume all attributes to the beginning state;
[Release Only Pan/Tilt] ---- Resume Pan and Tilt to beginning state and hold other attribute channels
except for HTP channel.
7.7.10. Direction
If it is a Cue-lists playback, press [Direction] can set the Cue-lists direction to ‘forward’ or ‘backward’.
7.7.11. Run Mode
If there is a Cue playback, you can select one of the modes:
Mode=Time ---- Enable both HTP and LTP times. If the times are set to 0, the value of the HTP channel
depends on the fader position.
Mode=Fader ---- Disables any set times. The values of HTP and LTP channels depend on the fader
position.
7.7.12. Release Mode
If there is a Cue-lists playback, press [Loop run] option can change the run mode into [Stop in Last Step].
7.8. Reload a Cue
The controller allows you to reload the attribute values of fixtures from one of the whole Cue-lists.
You may load in the values of the needed attributes from one of the cues by option [Load Cue to
Program] after selected [Playback Parameters].
At this time, you may find all indicators of attribute keys are on. You may press the attribute keys
to cancel selected so that the non-selected attributes will not be loaded in.
You can select the playback that needs to be reloaded.
If there is a cue playback, the fixtures include in the cue will be selected automatically.
If there is a Cue-lists playback, you may select one of the cues from the Cue-lists and select [Load
Selected Cue]. It will return to ‘LIVE SHOW’ and fixtures included in the cue will be selected automatically.
To Next Page
Loading...