TWO-WAY REMOTE CONTROL
The remote control has a red indicator. It sends out signal but also gets signal feedback from the camera
as well. When the remote controls sends out signal, it will flash once. When the camera receives signal
(executive command) successfully, the red indicator will flash again. If the camera does not get signal,
the remote control will only flash once. Using this information, you can check the camera status by
following the indicator, usually when you cannot see the camera easily.
OVERVIEW
Main Buttons:
Time on LCD (for example):
02:46:48 ----- The remaining video record time
2014-1-1 08:09:10 ----- Actual real-time clock
To Next Page
Loading...