Fossil VX43 - Page 9

16 17
Chronograph Stopwatch VD54 (with date - VD53)
Time and Date Setting
1. Before setting the time, make sure the chronograph is stopped and set to zero (12:00) position.
2. Pull crown out to position 2.
3. Turn crown clockwise until the previous day’s date is displayed.
4. Pull crown out to position 3 when the second hand is at the 12:00 position.
5. Turn crown to set time.
NOTE: 24-hour hand moves correspondingly with the hour and minute hands. When setting the time be sure to
check that the 24-hour hand is set properly.
6. Return crown to position 1.
NOTE: When the crown is in position 2, do not press the pushers. Otherwise the chronograph hands will move.
Chronograph
1. Press A to start/stop the chronograph.
2. Press B to reset to zero.
Split Time
1. Press B while the chronograph is running.
2. Press B again to return to the chronograph.
3. Press A to finalize timing.
4. Press B to reset.
Chronograph Zero Reset
1. If either of the chronograph hands is not at the zero (12:00) position, pull crown out to position 3.
2. Press A to move hands clockwise; press B to move hands counter-clockwise.
3. Return crown to position 1.
A
B
1 2 3
24-HOUR
HAND
CHRONOGRAPH
MINUTE HAND
CHRONOGRAPH
SECOND HAND
Chronograph Zero Reset
If for any reason the chronograph hands do not return exactly to the zero (12:00) position:
1. Pull crown out to position 3.
2. Press A to reset the chronograph second hand, or press B to reset the chronograph minute hand. Each press of
the pusher will advance the corresponding hand one mark. If either pusher is held down for over 2 seconds, the
corresponding hand will advance continuously.
NOTE: Chronograph minute hand moves simultaneously with chronograph second hand.
3. Return crown to position 1 when chronograph hands are reset to zero (12:00).