Foster HR150-A - Disposal Requirements; Start-Up and Test Sequence; Controller and Basic Operations; Display Icons and Buttons

English
Disposal Requirements
If not disposed of properly all refrigerators have components that can be harmful to the environment. All old
refrigerators must be disposed of by appropriately registered and licensed waste contractors, and in accordance
with naonal laws and regulaons.
Start-Up and Test Sequence
Aer unpacking, clean and allow the cabinet to stand for 60 minutes before turning on (cleaning direcons
supplied within this manual). Ensure the cabinet is situated on a rm, level surface, away from both hot and
cold air sources, as this will aect its performance.
Make sure that a minimum clearance of 50mm above and around the cabinet is available for venlaon and
eecve operaon.
Connect the unit to a suitable mains power outlet and turn the supply on. Please do not plug or unplug the unit
with wet hands. The cabinet will start automacally displaying the actual internal temperature of the unit (area
where product is stored).
As the operang temperature has been pre-set no adjustments are required. Allow the cabinet to reach its
normal operang temperature before loading with product.
Display Icons and Buons
Icons Buons
Alarm Warning
Info & Set Point
Thermostat Output Acve
Manual Defrost & Decrease
Fan Output Acve
Increase & Manual acvaon
Defrost Output Acve
Standby/Exit
2nd Parameter Set Acve