Foster HR360 - Page 7

English
Troubleshoong
Alarms/Warnings -
During normal operaon the display will show either the temperature or one of the following indicators:
Defrost In Progress Condenser High Pressure Alarm
Controller In Standby
Room High Temperature Alarm
Condenser Clean Warning Room Low Temperature Alarm
Door Open Alarm Probe T1 Failure
Condenser High Temperature Alarm Keypad Locked
Generic Alarm
(Some icons or switches are only visible during adjustment, when acvated by parameters or through operaon/
manual selecon).
Before calling your supplier please make sure that:
a. The plug has not come out of the socket and the mains power supply is on i.e. is the controller
illuminated?
b. Check to see if the unit is in standby
c. The fuse for the cabinet is intact
d. The cabinet is posioned correctly – cold or warm air sources are not aecng the performance
e. The condenser is not blocked or dirty
f. The products are placed in the unit correctly
g. Defrost is not in progress or required
If the reason for the malfuncon cannot be idened, disconnect the electrical supply to the unit and contact
your supplier. When requesng a service call, please quote the model and serial number which can be found
on the silver label located on the inside of the unit (starts E......).