Fostex 812 - Rear Panel Inputs and Outputs (35-50)

Hcwevei nute that the function ol the RTN 1 PAN (28)
deoends cn the connections made wth the EFFECT
RTN 1 jacts (40) (refer to the following illustrations).
When connections are mace to both L anc R of the
EFFECT H N 1 :ac<S (40), the 28. KIN 1 PAN serves
as a L-H Balance adjuster Eg l: The LEFT output or
a stereo output from a reverberator is sent to GROUP
buss 1 whle the RIGHT is sent to GROUP buss 2 at
equal levels.
Button down
Button up
Fg 2 Tne I FFT output of a stereo output from a
reverberator is sent to GROUP busses 5 and 7 at
ecua le/els while the RIGHT is sent nowhere
Button down
Button up
When a connection s made with only L, RTN i PAN (28)
sewes as a par. Eg. l: rhe monaural output tram a
delay is sent to GROUP busses 3 and 4 at equal levels.
Ec. 2: Tne monairal output from a delay is sent to only
GROUP buss 8.
NOTE: When a connect on is made wth only R. it is no:
possible lo assign the signal to an edd GROJP buss(ie
only to GROUP busses 2, 4. 6 and 8). In such a case
turn RTN 1 PAN (28) to the far right (EVEN) for level-
match ng purposes.
29. EFFECT RETURN 2 SECTION
This section assigns the siqnalfs) coming into the EF¬
FECT RTN 2 jacks (41) lo GROUP busses t 8. The func¬
tions of the switches are the same as n :he EFFEC
RETURN 1 SECTION (28).
30. EFFECT RETURN 3 SECTION
This sec:ion assigns the sgnal(s) comirg into EFFEC"
RTN 3 (42) jacks to GROUP busses 1-8 The lunctons
of the switches are the same as h the EFFECT RETURN
1 SECTION (28).
31. FL BAR-GRAPH METER
This meter displays the output of GROUP CUT jacks
1-8IL Irom left to nght resoectively.
32. PHANTOM LED
This LED is lif when the PHANTOM switch (51) s ON
33. SOLO LED
This LCD is li: when an INPUT SOLO switch (13) cr
GROUP SOLO switch (20) is prcssoc
34. PHONES JACK
The same sigral to the MONITOR OUT jack (47) is oui-
purted here.
REAR PANEL
35. XLR INPUT JACK
This is an XLR-type jack. It is mtenced for a baarced in¬
put signal (3rd pin is HOT). However, it does accomodate
an unbaanced signal as well; When connecting an un-
ba arced signal source, pins t and 2 become GROUND
and tne pfiantom switch (51) MUST be turned OFF.
Alto, t it uverrdden when there is a plug cornecled to
the PHONE INPUT jack (3G). ard the input signal to the
XLR INPUT jack (if there is one) goes nowhere.
Pin
36. P HONE INPUT JACK
This is a 6<? pyione-rype input jack and is unbalancec.
It does accomocate a balanced input signal, and. in
such a case, the TIP will be HOT and the RING will be
COLD.
B