Fostex B-16 - Page 11

All functions are the same with B-16 except for (4), (14), (17) and (18).
(4) REPEAT switch
This control has the function of repeating the tape between the ZERO position
and the CUE point memorized by the CUE button (14).
When this REPEAT button is depressed, the tape rewinds to the ZERO position
and immediately enters the PLAY mode. Upon reaching the CUE position, the
tape will again rewind to the ZERO position and then enter the PLAY mode.
If the tape is at display position of the counter, depressing this REPEAT
button will have no effect.
The REPEAT mode can be cancelled by any transport button other than RECORD (ZERO
RTN, F.FWD, REWIND, STOP and PLAY).
(14) CUE button
This button is for memorizing the tape position at which the REWIND mode is
entered from PLAY during the REPEAT mode.
This memorized CUE position will be renewed each time the CUE button is depres 
sed.
Although the CUE button can be depressed during any mode to enter a new tape
position, this function is not possible if the counter is showing a position,
(17), (18) REMOTE switch
This selects whether the control should be at the B-16 or the Remote
Control Unit in terms of the RECORD TRACK selector and the INPUT MONITOR
selector.
When LED (18) is lit, the RECORD TRACK and INPUT MONITOR selectors can be
controlled at the Remote Control Unit but not at the B-16.
The other control switches, however, can be operated at either the B-16 or the
Remote Control Unit, as they are wired in parallel.