21
For quick start of the thermal imager, please follow the
procedures as below:
1. Insert the battery into the battery compartment of the
thermal imager. (Make sure the battery is fully charged
before starting up the thermal imager)
2. Insert TF storage card into the TF card slot.
3. Long press the Power Button to turn on the thermal
imager.
4. Aim the thermal imager toward the object of interest.
5. For 320M series, adjust the Manual focus ring to get a
clear image.
For 320F series, keep object distance of more than
0.5meters to stay focus.
6. Press the Capture Button to freeze the thermal image,
so that it can be analyzed in this interface.
7. Press the Capture Button again; the analyzed thermal
image will be saved.
Quick-Start
To Next Page
Loading...