7
periodically.
Caution > Please do not open the thermal imager' s shell
or modify it without permission. Repair services can only be
performed by authorized FOTRIC personnel.
Notice> After the thermal imager is turned on, it may
take about 10~15 minutes to warm up before accurate
measurement.
Notice> Every thermal imager's temperature correction has
been performed before delivered from factory.
Warning > This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including
interference that may cause undesired operation.
Safety Information
To Next Page
Loading...