Prohibition Mark
Non-High-Speed and Mix Viscous Material
XII, Food Material and Mixing Method
If you use the mixer to stir the food, first you need to prepare food materials in your own way.
Then stir.
When stirring the food material in the process, you will find no matter what method of
operation,what you have to do is repeated operations, which is the only way to improve the
stirring effect of food. But do not over stir, which may adversely affect the texture of food.
After assessing the texture, uniformity, light quality and the laminated degree of the
finished products, you will find the Fude mixers save a lot of time.
Even for those generally require manual mixing and fine food, you can also get in the
mixer for mixing operation blessing.
Fu mixer gets the most efficient and fast way to stir the food material.
Fu is used to stir material while the operators do not need to have high requirements.
If you want to get the desired effect of stirring, just need to be careful to set the
operation time and adjust the stirring speed.
Fude mixer can be a long time to create uniform mixing effect.
XIII Capacity of the Mixer
After you complete the preparation of food material, consideration shall be given to
the mixer into the mixing bucket when the amount of material, Mixer presented in this
article "capacity table", can provide you with guidance. The "capacity table" values
listed, considering the barrel for mixing different sizes to accommodate the amount of
food materials and a variety of factors.
The capacity values listed in the table can be used for the proposed maximum amount
of material inputs.Whenever the material inputs is more than 25kg, mixing bucket
truck should be used.
Mixer capacity table used to determine the amount of material is shown below
To Next Page
Loading...