Founter MA20 - Installation Guidelines; Safety Labeling Explained

3
IV Installation Notice
1, The mixer should be placed in well-ventilated place.
2, The mixer should be placed with the top space of not less than 30cm, sides and
back wall distance of not less than 10cm, with no barriers around and space should be
left to take the barrel up and down.
3, To avoid the mixer near heat sources, direct light and moisture.
4, Place on the flat and solid ground (If unstable, you can pad the hard wood).
5, The power cord (or plug) connected to the outlet. Do not share the same outlet with
other power.
6, The mixer should not be placed in cold (below 5 ℃) or hot (above 40 ℃)
environment, nor outdoors or in the rain. The best temperature is between 5 ℃ to
40 ℃. In general, when it is 40℃, the moisture is not more than 50%; when it is 20℃,
not more than 90%.
V Safety Labeling
Dear Fude Users,
Thank you for using Fude Mixer! To make you better read this manual and use the product, the
following is our interpretation of some signs.
Prohibition Mark
With the sign any action
is to be prohibited,
otherwise the product may cause damage or
endanger the personal safety of users.
Warning Mark
With the sign any action should
strictly follow the
requirements of the operation, otherwise the product
may cause damage or endanger the personal safety
of users.
Caution Mark
With the sign any action should be paid attention to,
otherwise it will cause product damage because
improper operation will cause other losses