1. DO NOT use the drill press until it is completely assembled and installed according to the
instructions of this manual.
2. FIX the drill press on a supporting or flat surface. If the supporting or the flat surface move
during use, FIX them to the ground.
3. START the drill press after removing all objects (tools, discards, etc..).
4. DO NOT start the drill press when the bit is in contact with the workpiece.
5. ONLY USE bits, tools or other accessories provided with a spindle connection pin smaller
than 13mm for F11-951 model, and smaller than 16 mm for F11-991 model.
6. ALWAYS KEEP your hands and fingers away from the bit or the tool.
7. DO NOT put your hands in uncomfortable positions, they could slide on the tool.
8. DO NOT TRY to drill a workpiece which does not have a flat surface, unless you use a
suitable horizontal base.
9. ALWAYS USE a locking device to prevent the workpiece from turning during working.
10. USE recommended speeds to drill the various materials according to the bit you are
using.
11. BE SURE that all locking handles are locked before starting the machine and that the
transparent protection of the spindle is in its position.
12. DO NOT carry out any assembly or preparation tasks on the workbench when the drill
press is working.
13. BE SURE that the bit or the tool are not damaged and that they are properly blocked in
the spindle before use.
14. BE SURE that the wrench of the spindle has been removed from the spindle before
starting the machine. Only use the spindle wrench provided with the drill press.
15. ADJUST workbench’s height and bit’s descent depth in order to prevent the bit from
drilling the workbench.
16. ALWAYS switch off the machine before removing the chips from the workbench.
17. BE SURE that big workpieces are correctly supported at workbench’s height during
cutting.
18. DISCONNECT THE MACHINE FROM THE POWER SUPPLY, remove the bit or the
tool before moving away from the machine.
19. REPLACE the missing or damaged parts. Do not use the drill if all its parts do not work.
SPECIFIC SAFETY INSTRUCTIONS FOR DRILL PRESSES
To Next Page
Loading...
Need help?
General
