32
40. NEVER USE thinners to clean the plastic pieces of the machine. Thinners can melt or
damage the material. Only use a damp cloth for cleaning plastic workpieces.
41. INSTALL the saw PERMANENTLY on a plane surface before using it.
42. DO NEVER CUT any metals or materials that can produce dangerous dust.
43. ALWAYS USE the table saw in a well ventilated area. Often remove the sawdust.
Remove carefully the sawdust that is inside the saw to avoid the risk of fire.
44. DO NOT use saw blades which are damaged or deformed or high speed blades in high
alloy ( as for example HSS ).
45. USE only saw blades recommended by the manufacturer, in compliance with EN 847-1
standard.
46. USE only correct saw blades, which are suitable to the material to be cut and on which
the marked speed is higher than the one of the machine. When changing the blade,
check if external diameter and bore diameter are correct, that cutting width and the blade
body are not thinner than the riving knife width. Transport the saw blade inside its case.
47. CHANGE the plastic table inlay which is located on the table around the blade when
worn or damaged.
48. USE this table saw only to cut wood and similar materials.
49. CHECK often if the supply cable is damaged, and in this case get it repaired by an
authorised after sales centre. Check often the extension cord and change it if it is
damaged.
50. CONNECT the machine to a dust-collecting device and USE ear protective devices and
the dust mask.
To Next Page
Loading...
