Foxfury Lighting Solutions BREAKTHROUGH BT2 - BATTERY LIFE; BT2 BATTERY LIFE; BT2+ BATTERY LIFE

5
4. Insert four (4) AA batteries into the Battery Holder. Reference the plus
(
+
) and minus (
-
) symbols located on the front of the Battery Holder for
proper installation.
REASSEMBLING THE BT
1. Once batteries are installed, push both halves of the Battery Holder back
together. A ‘click’ should be heard as the halves become locked together.
2. Reinsert the Battery Holder into the Light Body. Take note of the Key Way
(groove that the Battery Holder aligns with).
3. Close the Battery Door and turn the Locking Mechanism clockwise.
NOTE: Make sure the Battery Door is properly closed to maintain a
water tight seal.
For added protection, the Battery Door can be secured with a
secondary lock (Battery Door Lock Hole) by use of the provided Hex
K e y.
Test the light’s performance by activating the Power/Mode Switch
located on the right hand side of the light.
BT2 BATTERY LIFE
MODE BATTERY LIFE LUMENS
HIGH POWER 3 hours 200
LOW POWER 6 hours 40
FLASHING 12 hours 200
*Battery life may vary according to mode selected, battery quality and prevailing ambient conditions.
BT2
+
BATTERY LIFE
MODE BATTERY LIFE LUMENS
HIGH POWER 2 hours 700
LOW POWER 5 hours 100
FLASHING 8 hours 700
*Battery life may vary according to mode selected, battery quality and prevailing ambient conditions.