67
ENGLISH
RESTARTING THE ENGINE AFTER A LONG
PERIOD OF INACTIVITY
1. Drain the residual protective oil from the sump.
2. Fill the engine, as prescribed, with lubricant of the type and amount
indicated in the REFILLING table.
3. Drain the CFB protective fluid from the fuel circuit, carrying out
this operation as indicated under point 3 of PREPARING THE
ENGINE FOR A LONG PERIOD OF INACTIVITY.
4. Remove the plugs and/or seals from the suction, delivery,
ventilation and bleeder openings in the engine, restoring it to a
normal state of use. Connect the turbocharger suction inlet to the
air filter.
5. Connect the fuel circuits to the machine’s fuel tank, completing the
operations as indicated in point 4 of PREPARING THE ENGINE
FOR A LONG PERIOD OF INACTIVITY. During filling
operations, connect the fuel return pipe to a collection tank, so as
to prevent any residual CFB protective fluid from flowing into the
machine's fuel tank.
6. Check the engine and fill it up with coolant as prescribed.
7. Start the engine and keep it running until the idling speed rate has
stabilised completely.
8. Check that the instruments on the on-board control panel/s are
showing plausible values, and that no alarms are shown.
9. Stop the engine.
10. Remove the "ENGINE WITHOUT OIL" signs from the engine.
To Next Page
