To Next PageTo Next Page
Need help?Do you have a question about the Fracarro KDSR and is the answer not in the manual?
Guidelines for installing the KDSR product indoors, in a dry place, away from heat sources.
Connecting the antenna system to the earth electrode of the antenna system according to EN60728-11.
Configuration options for the TPE programmer and general device settings.
Menu for configuring headend devices and system navigation.
Options for emulating the KTP programmer functionality.
Settings related to the input signal parameters for the KDSR module.
Settings for configuring the output signal parameters of the KDSR module.
Access to measurements of input and output signals.
Functions for loading and saving input presets.
Settings for LNB remote power and DiSEqC tone control.
Configuration of frequency, symbol rate, and FEC for the transponder.
Viewing available programs and their detailed properties like service ID and PIDs.
Configuring the output signal frequency by selection or channel.
Setting the output channel based on country or specific channel numbers.
Configuring video format (e.g., 16:9, Letter Box) and video test patterns.
Setting audio output type (mono, stereo) and adjusting audio level.
Video format, test settings, audio output type, and audio level for KDSR-AV.
Configuring the standard output video format for KDSR-AV units.
Displaying software version, BER, and S/N ratio of the input signal.
Selecting language, baud rate, and timeout for TPE programmer.
Adjusting TPE display contrast and restoring default settings.
Navigating headend menus, OSD visualization, and headend scanning.
Copying configurations, factory setup, and module address settings.
Functionality for emulating the KTP programmer.
General