FRAM FCD-V8T2B - Automatic Fault Warnings and What to Do

43
PROBLEM
REASON
SOLUTION
The filter cleaning warning symbol is on.
The lint filter might be
unclean.
Clean the filter.
The filter seat might be
clogged by lint.
Clean the filter seat.
There might be a layer that
causes obstruction on the
surface of the lint filter.
Wash the filter with
lukewarm water.
The condenser cleaning warning symbol is on.
The condenser might be
unclean.
Clean the condenser.
The program cannot be started and the filter
warning led is blinking
The filter may not be
placed
Replace the filter
The filter warning led is
blinking even though the
filter is placed
Call technical service
The program cannot be started and filter warning
led is blinking
The filter may not be
placed
Call technical service
The program cannot be started and condenser
warning led is blinking
The condenser may not be
placed
Replace the condenser
The program cannot be started and both
condenser and filter warning LEDs are blinking
The condenser and filter
may not be placed
Replace the filter
The filter and condenser
warning LEDs are blinking
even though the filter and
condenser are placed
Call technical service
Your tumble dryer is equipped with a built-in fault detection system, indicated by a combination of flashing
operation lights. The most common failure codes are shown below.
ERROR CODE
SOLUTION
E03/
Empty the water tank, if problem does not solve, contact the nearest
authorized service agent.
E04
Contact the nearest authorized service agent.
E05
Contact the nearest authorized service agent.
E06
Contact the nearest authorized service agent.
E08
There may be voltage fluctuation in mains. Wait until voltage is
appropriate for working range.
13. AUTOMATIC FAULT WARNINGS AND WHAT TO DO