Need help?Do you have a question about the Framo SD125-5 and is the answer not in the manual?
General| Type | Submersible Dewatering Pump |
|---|---|
| Motor size | 5.5 kW |
| Power | 5.5 kW |
| Frequency | 50 Hz |
| Speed | 2900 rpm |
| Material | Cast Iron |
Detailed specifications and parameters for the Framo SD125-5 cargo pump, covering connections, pressures, and weights.
Detailed specifications and parameters for the Framo SD150-5 cargo pump, covering connections, pressures, and weights.
Step-by-step guide for removing the pump's impeller and wear rings, including required tools and procedures.
Procedure for safely disassembling the pump's lip seal system, detailing tools and careful handling of ceramic parts.
Instructions for reassembling the pump, focusing on seal checks, torque values, bolt preparation, and alignment.
Procedure to dismantle the mechanical oil seal assembly, including necessary tools and detailed steps for removal.
Steps for removing the pump's bearing housing, specifying special tools and handling of components like back-stop units.
Instructions for safely draining the pump's hydraulic section, a crucial step before dismantling the hydraulic motor.
Procedure for removing the hydraulic motor, covering the use of jacks, extractors, and essential preparation steps.
Guide for reassembling the pump post hydraulic motor repair, detailing motor, back stop unit, and seal installation.
To Next Page