Franke Little Butler LB2200 Series User Manual

Franke Little Butler
Installation and User Guide
Hot Water Dispensing System
Model Series LB2200, LB3200, & LB4200
LB2200
LB3200
LB4200
Franke Consumer Products Inc
Kitchen Systems Division
3050 Campus Drive, Suite 500
Hatfield, PA19440
USA
Phone +1 215 822 6590
Fax +1 215 822 5873
fks.filter@franke.com
www.frankeksd.com
1/4” To 3/8” Reducer
Push Fit
O Ring Seal
Out Of Heating Tank
1/4” Tee Connector
Backnut
Lock Washer
Clamp Plate
Shut Off Valve
Push Fit
*Cut to Length for
Franke Canister
Silicone Tube Hot Water
Into Heating Tank
Cold Water Line
12” Long
Inlet Tubes
Heating Tank
Connections To

Franke Little Butler LB2200 Series Specifications

General

Brand	Franke
Water Filtration	Yes
Model	Little Butler LB2200 Series
Type	Water Dispenser
Cold Water Temperature	8°C
Tank Capacity	2.5 liters
Material	Stainless Steel

Summary

Installation, Care and Maintenance

Overview of Installation

System components: dispensing head, canister, heating tank. Connections for water supply and potential chiller diversion.

Preparation and Mounting

Prepare sink hole, position components, feed tubes, and assemble clamp plate, lock washer, and backnut.

Supply Provision and Pipework

Connect 3/8" supply tube with tee and shut-off valve. Flush pipework before installation.

Seasonal Shutdown Procedure

Operate hot lever, shut off main supply, operate both levers to release pressure.

Troubleshooting

Water Not Hot

Check electrical supply, temperature control, fuse, or circuit breaker. Test after 15 minutes.

Dripping or Sputtering Hot Water

Check for excessive venting. Lower temperature or check for kinked tubes.

No Water Flow

Ensure shut-off valve is open and supply tube is not kinked.

Spare Parts and Warranty

Spare Parts Identification

Identify correct reference numbers from the exploded diagram for ordering spare parts.

Limited Warranty Terms

Five-year warranty for manufacturing defects; covers original owner, installation, and normal use.