Need help?Do you have a question about the Franklin Fueling Systems INCON TS-550evo and is the answer not in the manual?
General| Brand | Franklin Fueling Systems |
|---|---|
| Model | INCON TS-550evo |
| Category | Recording Equipment |
| Language | English |
Explains the meaning of warning, caution, and danger symbols in the document.
Details how alarms and warnings alert users and their custom programming options.
Covers electrical lockout, code adherence, work area security, and explosion hazard prevention.
Details configuring the Comm 1 serial port for Modbus RTU.
Explains enabling and accessing Modbus TCP via Ethernet port 502.
Guides on connecting a PC to the console via Ethernet or serial port.
Provides step-by-step instructions for accessing network settings via Windows Control Panel.
Instructs on how to access and modify network adapter settings.
Explains how to configure the PC to automatically obtain an IP address.
Details the process of manually assigning a static IP address to the PC.
Provides steps to verify the network connection status and link lights on the hardware.
Defines IP Address and Network Mask and their roles in network communication.
Explains the Gateway setting for accessing the nearest router port.
Explains Little Endian ordering for 32-bit values and Two's Complement for negative numbers.
Presents a table mapping register addresses to data sets and types for Modbus communication.
Lists register offsets, unit types, and data types for system unit configurations.
Provides a table mapping register values to unit types and precision for length measurements.
Lists units and precision for volume, temperature, and density measurements.
Lists register values, unit types, and precision for mass measurements.
Details register sets for tank data including status, alarms, levels, and volumes.
Defines the status bits for the Tank Status Register, indicating tank conditions.
Lists the bit definitions for various tank alarm conditions.
Outlines the register set for manifold data, including status, alarms, and volumes.
Defines status bits and lists alarm bits for manifold data.
Defines status bits and maps values to states for 2-wire sensors.
Details 3-wire sensor register sets, types, and state mappings.
Defines Mag Sensor register sets and lists status/alarm bits.
Defines relay status bits and maps values to relay states.
Defines TPI controller status bits and maps pump states.
Defines status bits and maps values for Low Voltage and AC Inputs.
Defines GIO input status bits and maps values to GIO input states.
Provides a comprehensive table of alarm codes, device types, and alarm names for system alarms.
Lists alarm codes and names for Secondary Containment Monitoring.
Lists alarm codes and names for various sensor types.
Lists alarm codes and names related to line leak detection.
Lists alarm codes/names for printer, modem, and VR emulation issues.
Lists alarm codes and names for Turbine Pump Interface alarms.
Lists alarm codes and names for input and PLC related errors.
Lists alarm codes and names for compliance-related alarms.
To Next Page