Need help?Do you have a question about the Franklin Fueling Systems TS-LS500 and is the answer not in the manual?
General| Model | TS-LS500 |
|---|---|
| Manufacturer | Franklin Fueling Systems |
| Application | Fuel Tank Monitoring |
| Power Supply | 12-24 VDC |
| Communication | RS-485, Ethernet |
| Display | LCD |
Lists and defines abbreviations used in the manual.
Outlines the requirements for optimal line pressure for the LS500.
Details minimum pressure requirements for the LS500.
Provides physical dimensions and connection types for the TS-LSU500.
Step-by-step guide for installing the TS-LS500 transducer.
Explains the function of the AC input module for dispenser hook signals.
Details the setup and parameters for the 4-20mA input module.
Describes the 2A and 10A relay modules and their use for STP control.
Explains TPI setup and communication for line leak and STP operation.
Guide to setting up lines for leak testing with parameter configuration.
Details the status indicators and data available on the TS-LS500 status screen.
Explains the functions for controlling line status and tests.
Covers starting, stopping, and monitoring the line learning process.
Lists essential tools and components for pre-operational testing.
Steps to purge air from lines before leak detection testing.
Importance of setting the line pressure to zero for the learn process.
Procedure for testing line stability before the learning process.
Conditions and reasons for performing the learn or re-learn process.
Step-by-step instructions for the line learning procedure.
Explains various messages displayed during the learn process and their meanings.
Details the content and format of TS-LS500 line leak reports.
Lists alarms and warnings during the learn process and operation.
Steps to identify, diagnose, and clear console alarms.
Steps to enable a line for monitoring and testing.
Steps to disable a line channel to stop monitoring and testing.
To Next Page
