Franklin JEXtream – Performing a Factory Reset
Page 1 of 3
Performing the Factory Reset
You can perform a factory reset on the the JEXtream hotspot by following these steps:
1. Under Settings on the device screen, select Factory Reset, and select “Yes” when
prompted to respond that you want to reset the device to the original factory
settings.
A factory reset can also be performed by doing the following:
1. Remove the back cover using the notch on the side of the hotspot;
2. Press down the reset button (see below) for 3 seconds and release;
3. Replace the back cover;
4. Your JEXtream will reset to factory default setting and restart automatically
Restoring the SFL Broadband Settings
Once the factory reset is complete, the Program Administrator will need reset the SFL
Broadband settings on the device, using the following instructions:
1. Turn on and connect to the JEXtream
2. Once connected to the JEXtream, access the hotspot admin site at
http://mobile.hotspot/ (NOTE: This site can only be accessed while connected to the
hotspot on your laptop, phone, tablet, etc.).
3. You will be prompted to login to the site using a password for the device. As the
factory settings have been restored, the initial password for access to the site is
“admin”, which you will be prompted to change. The password needs to be set to
“Sfladmin1!”
NOTE: The Sfladmin1! password is for accessing the admin site only. The password
for connecting to the device will remain the same, and will appear on the device
itself.
To Next Page
Need help?
General
