Need help?Do you have a question about the FRANKLINWH aGate X-01-AU and is the answer not in the manual?
Guidance on selecting installation locations, considering site conditions, clearances, and access routes.
Procedures and safety precautions for safely moving the aPower and aGate units before installation.
Step-by-step guide for safely unboxing the aPower unit from its packaging.
Instructions for safely standing up the aPower unit after unboxing, requiring multiple installers.
Guidance on transporting the aPower unit to its final installation location, including use of equipment.
Instructions for mounting the required bracket for the aPower unit on walls or floors.
Steps for safely unboxing the aGate unit and its associated accessories.
Instructions for removing the inner panel and door to access aGate components for installation.
Guidance on preparing cable entry points (knockouts) on the aGate for conduits.
Instructions for installing optional Smart Circuits and Generator modules into the aGate.
Steps to access the wiring compartment of the aPower unit by removing covers and panels.
Instructions for removing specific accessories, like charging cables and protective rings, from the aPower.
Procedure for installing conduit adaptors into the aPower's cable holes for secure wiring.
Connecting the Wifi Com Kit to activate aGate commissioning and ensure proper module connection.
Setting up communication between the FranklinWH mobile app and the aGate via its Wi-Fi hotspot.
Connecting the aGate to the home network using a cable for remote access and functionality.
Establishing the communication link between the aGate and the aPower units using network cables.
Details on RS485 communication setup and DRM0 signal control for grid monitoring and system operation.
Information on aGate terminals, applicable cable types, wiring torque, and stripping lengths for compliance.
Steps for connecting a single aPower unit to the system, including cable stripping length requirements.
Step-by-step guide for correctly starting up the Franklin Home Power system.
Step-by-step guide for safely shutting down the Franklin Home Power system.
Prerequisites and checks required before commencing the FHP system commissioning process.
Steps for setting initial system parameters and configuring the FHP via the FranklinWH mobile application.
Detailed electrical specifications, ratings, and compliance standards for the aGate unit.
General| AC Input Voltage | 230V |
|---|---|
| AC Input Frequency | 50/60 Hz |
| Nominal AC Output Voltage | 230V |
| Nominal DC Voltage | 48V |
| Charge/Discharge Current | 50A |
| IP Rating | IP65 |
| Communication Interface | RS485, CAN |
| Warranty | 10 years |
| Operating Temperature | -20°C to 50°C |
| Communication | CAN, RS485 |
| Cycle Life | 6000 cycles |
To Next Page