Fraser MagnaTrack - User Manual

1
PAGE
VERSION: 200619
LICENSED FABRICATOR OF MAGNATRACK
CARE & MAINTENANCE and WARRANTY - MAGNATRACK SYSTEMS
CARE&MAINTENANCEandWARRANTY
MagnaTrackSystems
FraserShadingSystemsMagnaTrackScreensystemisdesignedtoprotectandenhanceyour
outdoordiningareaorlivingarea,andcreateausablespaceyear‐round.Thescreensystemcan
beusedforprivacy,bugprotection,solar,blowingwinds(upto120KPH(75MPH)inthefull
deployedposition),andtocontroltheclimateandwindflow.
OPERATIONOFTHESCREENS
ToLOWERthescreenpresstheDOWNbuttonontheremoteandthescreenwilldeploytothe
presetbottomlimit:
***Makesurenoobstructionsareunderthescreenduringthisprocess,
Ifthescreenislowereddownonanobject,stopthescreenimmediately
ortheObstacledetectionfeatureinthemotorwillactivate
andshouldraisebackuptoallowremovalofobject.
Ifthemotordoesnotstopwhenobjectisunderthescreenduringdeployment,pressthecenter
STOPbuttonontheremoteimmediatelyandRemoveobject,thencontinuetolowerthescreen:
‐ ToraisethescreenpresstheUPbuttonontheremoteandthescreenwillretracttothe
presetlimit.
‐ Youcanstopthescreenatanypositionduringtheraisingorloweringofthescreenby
pressingtheSTOPbutton.
***Ifthescreendoesnotfullydeploytothefloor,ortheweightbarishanginguneven
pleaseleavethescreeninthatpositionandcontactyourauthorizeddealerASAP.
***Raisingthescreencouldcauseadditionaldamage.
RESETTING/ADJUSTINGLIMITSONSIMU/SOMFYMOTOR(NOTEDONREMOTE)
‐ Toadjustthelimits,youmustletthescreenraiseorloweruntilthemotorstops!(even
ifitisnottothedesiredposition)
‐ WhenthescreenisretractedorloweredtothePresetlimityouwishtoadjustPRESS
ANDHOLD,BOTHTHEUPANDDOWNATTHESAMETIME(FOR7to10SECONDS)UNTIL
THEMOTOR/WEIGHTBARJOGSUP/DOWN.
‐ Afterthemotorjogsyoucanraiseorlowertothedesiredposition.
‐ THEN,PRESSANDHOLDTHESTOPBUTTONUNTILLTHEMOTORJOGStoencodethe
newlimitsetting.
Thiswillcompletetheprogrammingprocessandchangethelimits.

Fraser MagnaTrack Specifications