Important Safety Information
Explanation of Attention Words and Symbols Used in this Guide
This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid
possible injury or death.
WARNING indicates a hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION, used with the safety alert symbol, indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
CAUTION, used without the safety alert symbol, indicates a hazardous situation which, if not avoided, could result in harm to your pet.
• Do not use this product if your pet is aggressive or is prone to aggressive behavior. Aggressive pets can cause severe injury and even death to owners and
others. If you are unsure whether this product is appropriate for your pet, please consult your veterinarian or a certied trainer.
• Risk of explosion if battery is replaced by an incorrect type. Do not short circuit, mix old and new batteries, dispose of in re or expose to water. When
batteries are stored or disposed, they must be protected from shorting. Dispose of used batteries properly.
• It is vitally important that you and your pet remain safe during training. Your pet should be on a strong leash that is long enough for him to attempt to
chase an object but short enough for him not to reach a road or other unsafe area. You must also be physically strong enough to restrain your pet if he tries
to chase.
• This product is not a toy, keep away from children. Use it only for dog training purposes.
• Proper t of the receiver collar is important. A collar worn for too long or made too tight on a pet’s neck may cause skin damage, ranging from redness to
pressure ulcers. This condition is commonly known as bed sores.
• Avoid leaving the receiver collar on a pet for more than 12 hours per day.
• When possible reposition the collar on a pet’s neck every 1 to 2 hours.
• Regularly recheck the t to prevent excessive pressure; follow the instructions in this guide.
• Never connect a leash to the receiver collar; it will cause excessive pressure on the contact points.
• When connecting a leash to a separate collar, do not allow it to put pressure on the receiver collar.
• Wash the pet’s neck area and the contact points of the receiver collar weekly with a damp cloth.
• Examine the contact area daily for signs of a rash or a sore.
• If a rash or sore is found, discontinue use of the receiver collar until the skin has healed.
• If the condition persists beyond 48 hours, see your veterinarian.
• For additional information on bed sores and pressure necrosis, please visit our website.
• This product must be used only on healthy dogs. If you’re not certain that your pet is in good health, we recommend that you take your pet to a
veterinarian before using this product.
In the Box
• 6V battery (installed)
• Collar
• Strap
• Probes
- Short (installed)
- Long
• Allen Wrench
• Test Light Tool
ontact
LED
On/Off
Button
Replace Battery
6V Alkaline
Bark Collar
To Next Page
Need help?
General
