FreedConn T-COM - Device Operation; Fitting the Receiver to Your Helmet; Charging the Bluetooth Device; Powering On and Off

Charging the BluetoottrDOevice
Before using this device, fully charge the Bluetooth device.
1. Insert the USB plug of the charging cable into the small USB jack on the headset. Insert the other
end of the charging cable into the Power Adaptor or your computer’s USB port.
2. While charging, the red LED on the headset module will illuminate, when the charging is finished,
the red LED will switch off. A normal charge from a low battery will take about 4 hours.
Tip: To maintain long life from the internal polymer battery, charge your device at least once each
month.
Powering On and Off
1. To tum the device on, press the PowerSntercom button for 3 seconds until you hear a beep. a blue
light will flash quickly 3 times and then continue short flashes at regular intervals.
2. To tum the device off, press the Power/Intercom buUon for 5 seconds until you hear a beep. The