headset and LED lights will tum off.
Pairing to your Bluetooth@Enabled
Mobile Phone
1. Place your Bluetootff’enabled phone and the Bluetoottfreceiver near each other (within Im).
2. Make sure the Bluetoot~receiver is turned off.
3. Press and hold down the Power/Intercom button for 8 seconds to tum on the Bluetooth~devices
until you see a red & blue lights Dashing. You will also hear a “DuDu” tone when the unit enters
pairing mode.
4. Adivate the Bluetoottf”fundion on your mobile phone and search for the device. You may need to
refer to your phones instructions to do this.
5. Choose the Bluetootfr’device named T-COM then choose to pair this device with your phone. If
your phone asks for password, it is 0000.
6. The Bluetooth~device will beep twice, your phone will confirm that pairing was successful.
Pairing 2 Devices In Intercom Mode
1. Place both receivers near each other(within Im).
2. Make sure both receivers are turned off
3. Press and hold down the Power/Intercom button on both units at the same Brno for approx 6
seconds, until the receivers beep twice. The red & blue lights will flash alternately.
4. Quickly press the Power/Intercom button on one of the receivers. This will now search for the other
receiver so they can be paired.
5. When they have successfully paired, the red & blue lights will then change to blue
only(flashing)and the receiver will beep once.
Pairing 3 Devices In Intercom Mode
1. Follow the above procedure for each combination of the three units.(A-B, A-C, B-C).
2. Firstly, pair two devices A and B as described above. Secondly~ tum off A and B, pair A and C as
described above. Thirdly, tum off C and A, pair B and C. At Last, Tum on A.
3. Any one of them can connect one of the two by press Power/intercom button once or twice From
standby press the Power/Intercom button 1 time for one of the pairings to be called, or 2 times for
the other pairing to be called.
4. The pairing for 1 or 2 presses will depend on the sequence in which you paired
the 3 helmets, but once paired the relevant pairings will maintain the number.
5. Pressing the Power/Intercom button of A 1 time to call C and 2 times to call B. Pressing the button
of B 1 time to call C and 2 times to call A. Pressing the button of C 1 time to call B and 2 times to call
A.
To Start A Conversation Via Intercom
1. Once the two headsets are paired with each other, press the Power/InWrcom button on either
receiver to begin.
2. Use the Jog wheel to increase or decrease the headset volume. Tip: You only need to press the
Power/Intercom button once to establish a connection; conversation between the two paired
headsets can now be carried out hands free.
To End A Conversation Via Intercom
Press the Power/Intercom button on either of the receiver. Tip: If the intercom headset is also paired
with a mobile phone, the intercom conversation will be automatically disconnected to answer the
phone when there is an incoming call. The intercom function will resume once the has ended.
To Answer An Incoming Mobile Phone Call
1. Press the Multi-function button on the receiver while the phone is ringing.
2. Use the Jog Wheel to increase or decrease the headset volume.
Tip:The incoming call will answer automatically once the phone has rung for 15 seconds.
Rejecting A Mobile Phone Call
When you hear the phone ringing, immediately press and hold the Multi-function button on the
headset until you hear a beep.
Ending A Mobile Phone Call
To Next Page
Loading...