Freedom Somerset - User Manual

3" Temporary
Spacer Blocks
Make sure your project meets local building codes before beginning installation
*2 Person Installation Recommended
Closely Follow Post Installation Instructions before beginning
Cut rails to length. If installing full length (uncut) rails, skip to Step 2.
a. Place rail across post opening leaving equivalent spacing from the last picket and
post on each end (Fig. 1).
b. Mark rail  ush with post (Fig. 2).
c. From marked line, mark additional parallel line 1/4" from  rst line, allowing for
bracket clearance (Fig. 2).
d. Carefully cut the top and bottom rails with a saw (using a  ne tooth carbide blade).
Cut two 3" tall temporary wood spacer blocks (not included) to insert under ends of
railing sections to temporarily assist in aligning section (Fig. 3).
Slide top and bottom rail brackets on ends of pre-built rail sections (Figures 4 & 5).
Slide rail section and brackets between posts and on top of temporary wood spacer
blocks. (Position wood spacer blocks next to installed aluminum posts) (Fig. 3).
Using a 1∕8" drill bit, carefully pre-drill all four bottom bracket screw holes on one post (Fig. 6).
Install 3/4" screws (included) to attach bracket to post (Fig. 7).
Repeat steps 5 & 6 for second bottom bracket.
Using a 1∕8" drill bit, pre-drill all four top bracket screw holes on one post (Fig. 8).
Install 3/4" screws (included) to attach bracket to post (Fig. 9).
Repeat steps 8 & 9 for second top rail bracket.
Using a 1∕8" drill bit, pre-drill all brackets (top and bottom) through side hole (Fig. 10).
Install 3/4" screws (included) into side bracket holes to attach brackets to rails (Fig. 11).
Fig. 1
Fig. 1
Fig. 2
Fig. 3 Fig. 4
Fig. 5
Fig. 7
Fig. 9
Fig. 6
Fig. 8
Fig. 10
Somerset & New Castle Aluminum Rail & Stair Kit
PLEASE READ OWNER'S MANUAL COMPLETELY BEFORE INSTALLING
INSTALLATION INSTRUCTIONS
Level
Drill & Bits
Hacksaw
Tape Measure
Pencil
Clamps
TOOLS/MATERIALS NEEDED:
1
2
3
4
5
6
7
8
9
10
11
12
For more information visit www.FreedomProduct.com or call 1-888-418-4400.

Summary

Aluminum Rail Installation Steps

Preparation and Rail Cutting

Follow post instructions and cut rails to the correct length, allowing for bracket clearance.

Bottom Bracket Installation

Pre-drill and attach bottom rail brackets to posts using specified screws.

Top Bracket Installation

Pre-drill and attach top rail brackets to posts using specified screws.

Secure Brackets to Rails

Pre-drill brackets through side holes and attach them to the rails with screws.

Stair Rail Installation Steps

Post Alignment and Rail Positioning

Align posts, position and clamp stair rail sections, ensuring consistent spacing.

Stair Rail Cutting and Preparation

Mark rails based on bracket placement, add 1" for pre-determined measurement, and cut.

Attach Bottom Stair Rail Brackets

Slide brackets onto rails, pre-drill, and attach bottom brackets to the stair post.

Attach Top Stair Rail Brackets

Slide brackets onto rails, pre-drill, and attach top brackets to the top stair post.

Final Stair Rail Bracket Securing

Pre-drill all brackets through side holes and secure them to the stair rails.

Freedom Somerset Specifications

General

Brand	Freedom
Model	Somerset
Category	Other
Language	English