FreeFlight 2101 I/O Approach Plus

Need help?

Do you have a question about the FreeFlight 2101 I/O Approach Plus and is the answer not in the manual?

Summary

SECTION I - General Information

1.1 Introduction

Overview of the manual's scope and purpose, covering the GPS system.

1.2 Description of Equipment

Details the components of the GPS system, including RDU and antenna.

1.3 Technical Characteristics

Lists the technical specifications for the system components.

1.4 Parts and Equipment

Lists the required parts and equipment for installation kits.

1.5 Accessories Not Supplied

Information on installation requirements and GPS cable specifications.

SECTION II - Installation

2.1 General

Provides general information for installing the GPS navigation system.

2.2 Unpacking and Inspecting Equipment

Instructions for unpacking and inspecting the GPS system components.

2.3 Equipment Installation

Details the procedures for installing the GPS system components.

SECTION III - Checkout

3.1 General

Overview of installation checkout, system configuration, and operating procedures.

3.2 System Checkout

Procedures for verifying system installation and configuration.

3.2.1 Preliminary Test

Steps to verify installation accuracy before powering on the unit.

3.2.2 Installation Setup

Configuration steps for various system parameters during installation.

3.2.3 I;O Interface Check

Procedures to check the CDI and Annunciator interface.

3.2.4 GPS Receiver Tests

Tests to ensure proper GPS receiver operation and signal reception.

3.3 Final

Final steps and documentation after installation.

APPENDIX A - RTCA;DO-160 Environmental Qualification Forms

A.1 Receiver;Display Unit Environmental Qualification

Environmental qualification test results for the receiver/display unit.

A.2 GPS Antenna Environmental Qualification

Environmental qualification test results for the GPS antenna.

APPENDIX B - Serial Interface Specification

B.1 Introduction

Overview of serial communication capabilities and protocols.

B.2 Basic Communication Protocol Descriptions

Explains RS-422, RS-232, and RS-423 communication protocols.

B.3 Connector Pin Assignments

Defines pin numbers and functions for serial interface connectors.

B.4 Software Configuration of Serial Ports

User configuration options for serial ports.

B.5 Receive Ports

Details on receiving data formats and configurations.

B.6 Transmit Ports

Details on transmitting data formats and configurations.

APPENDIX C - External Inputs and Outputs

C.1 External Inputs

Details on various external inputs to the GPS system.

C.2 System Outputs

Details on various outputs from the GPS system.

APPENDIX D - Supplemental Type Certificates and Flight Manual Supplements

Information on STCs and FAA Approved Flight Manual Supplements

Information on obtaining STCs and FAA approved Flight Manual Supplements.

APPENDIX E - Local Geodetic Reference Datums

Datum Localities

Lists various geodetic reference datums and their corresponding localities.