Live Stream and Broadcast Via iPhone or
iPad
Freestream allows you broadcast the audio & video stream from the
transmitter via the 4G network of iPhone or iPad (WiFi+ Cellular) to
Youtube, Facebook and other online live platforms in real time. Set up
your live stream via Freestream App.
Note:
1. If your iPad does not support a cellular SIM card, streaming feature
support by a 4G network will not be available.
2. Your iPhone or iPad screen will mandatorily stay on in the process of
live broadcast.
3. If you close Freestream App in the process of live broadcast, the live
broadcast will stop.
Lithium Battery Low Power Warning
When the Lithium batteries run low, the red indicator light on to of the
device will blink to warn of low power, and the device screen will show
the battery level as one grid. Take the Lithium battery and charge it.
Note:
1. The kit does not support Lithium battery charging directly via Mini-
USB interface.
2. If you use 2 fully-charged 14500 batteries (3.7V, 800mAh), the
duration of the transmitter will be 90 minutes, and receiver will be 80
minutes. After repeated charge and discharge, the batteries eciency
will reduce and shorten the duration of batteries.
Restore Default Wi-Fi Password
The Wi-Fi password of the receiver can be customized via the
Freestream App. If you forget the password, you can follow the
following steps to restore the Wi-Fi password to the default value as
12345678.
1. Press and hold the Reel Key on the right side of the receiver for
more than 3 seconds, restarting the receiver automatically. When the
red light on the top of the receiver is o and the blue light on the top
of the receiver flashes slowly, press and hold the Pairing Key on both
the receiver and the transmitter for more than 3 seconds separately.
The blue lights on the top of the transmitter and the receiver will flash
rapidly which indicates that the transmitter and the receiver are in the
pairing status; the Wi-Fi will also be reconnected, and this process
lasts about 10 seconds.
2. When the blue lights on the top of the transmitter and the receiver
stop flashing, it is indicating that the transmitter and receiver have
completed the pairing process and implemented the Wi-Fi connection,
and the Wi-Fi password of the receiver has been restored to the
default value as 12345678.
3. Find the receiver SSID which is the 15 bit character string with
FREESTREAM_ as the prefix through the “Wi-Fi” item in the “Setting”
page of your iPhone/iPad. When prompted, enter the default
password to reconnect the receiver.
Note: If the blue lights on the top of the transmitter and the receiver
are still flashing rapidly for a long time, it is indicating that the pairing
process is not successful. Press and hold the Power Button on both the
transmitter and the receiver for more than one second to shut down
separately, and then reboot. When the red lights on the top of the
transmitter and receiver are o and the blue lights start to flash slowly,
press and hold the Pairing Key of the receiver and the transmitter
again for 3 seconds separately, and then repeat the above process.
To Next Page
Loading...