Transmitter Supports External Audio
When the audio jack on the right side of the transmitter is connected
to an external microphone, the output of the receiver will be the sound
of the microphone.
About the Pairing of Transmitter and
Receiver
The transmitter and receiver will be required to be paired in the
following two cases:
Case 1: When the receiver needs to be restored the default WiFi
password, it needs to be re-paired with the transmitter (for the
detailed operation instruction, please see above).
Case 2: The transmitter and receiver have been paired with each other
when they are out of the factory, however, the transmitter and the
receiver need to be re-paired if either is replaced in the case of loss or
damage.
Note: In addition to the above two cases, do not press and hold the
Paring Key on the transmitter under normal use of the product, since
it will cause the Wi-Fi to reconnect between the transmitter and the
receiver.
USB interface for Power Supply
For extended use, you can use the aliated two core USB power cable
to connect the outside portable battery or the aliated 5V 2A power
adapter in the package.
Note:
1. The aliated USB power cable in the package can only be used for
power supply, and it can not used for data transmitting.
2. Use the aliated USB power cable and aliated 5V 2A power
adapter in the package for power supply. Any issue caused by other
power supplies is not within the scope of warranty.
To Previous Page
Loading...