What to do if my FREEV EVS 312 Scooter has brake failure?
If your FREEV Scooter's brake isn't working, first check if the brake is pressed. If it is, release it. If the brake isn't pressed, inspect the connection cable between the brake and the instrument for a short circuit or interruption. If there's a short circuit or outage, replace the connection cable. If the issue persists, consider changing the brake lever.
What to do if my FREEV EVS 312 Scooter has a thumb accelerator error?
If your FREEV Scooter's thumb accelerator isn't working, first check if the thumb gas is pressed. If it is, release it. If it's not pressed, check the connection cable between the accelerator pedal and the instrument for a short circuit or open circuit. If there's a short circuit or outage, replace the connection cable. If the issue continues, replace the thumb gas.
What to do if my FREEV EVS 312 Scooter has an engine failure?
If your FREEV Scooter engine fails, first check if the engine and controller are connected via a cable; if not, connect them. If they are connected, disconnect the cable and measure the internal resistance of the three-phase cable of the engine. If the internal resistance is outside the reasonable range (usually 0.1? - 1?), replace the engine.
Why is my FREEV EVS 312 Scooter smelling burned and very hot?
If the FREEV Scooter is smelling burned or is very hot, the battery may be damaged or overheated. Do not touch the battery and take the scooter to a service center.
What to do if my FREEV Scooter has a high temperature engine?
If your FREEV Scooter engine overheats, allow it to cool down to working temperature. If the temperature is normal, check the connection cable between the motor and the short circuit controller and replace the connection cable if there is a short circuit.
Why is my FREEV EVS 312 Scooter running slow?
If your FREEV Scooter is running slow or sluggishly, it could be due to a low, damaged, or overheated battery. Do not touch the battery. Contact a service shop on whether to charge the battery or bring the scooter to the service centre.
What to do if my FREEV Scooter battery is leaking?
If your FREEV Scooter battery is leaking, it is likely damaged or overheated. Do not touch the battery or the leakage. Bring the scooter to a service centre.
What causes communication errors on FREEV EVS 312 and how to fix them?
If your FREEV Scooter has communication errors, check if the brake back light is ON. If the brake back light is not ON, it indicates that the control unit is not on. Replace the controller or instrument. If the brake back light is ON, check the connection cable between the instrument and the control unit for interruption.
How to fix controller failure on FREEV Scooter?
If the controller of your FREEV Scooter is damaged, replace it.
Critical warnings about reading the manual, environmental damage, fire risk, and component wear.
Guidelines on wearing helmets, battery checks, traffic laws, respecting pedestrians, and avoiding impairment.
Rules for single rider use, practice areas, protective gear, safe posture, and temperature limits.
Advice on handling obstacles, poor roads, slippery surfaces, speed limits, and water exposure.
Warnings about bad weather, extreme temperatures, maximum load, and handlebar stability.
Lists common issues like burning smell or slow running, with their causes and solutions.
Explains specific error codes (E1-E6) and corresponding troubleshooting steps for various failures.
To Next Page
General
