Table of Contents
Network ID…………………………………………………...……….19
IO Settings……………………………………………………...………...20-21
Enable FGRIO……………………………………………...……….. 20
Mapping……………………………………………….……...……….20
Time Out ……………………………………………..…...…………..21
Sensor Power………………………………………...………….…….21
IO Slave……………………………………………,,,…………………………….22-26
Operation Mode……….………………………...……………………..…….22
Call Book…………………………………...………………………………...22
Radio Transmission Characteristics………………….…………...………..23
Max and Min Packet Sizes ……………...……….………...………...23
RF Data Rate ……………………………………………...………….23
Retry Timeout ………………………………………..…..…………..23
Multipoint Parameters………………………………………..………….….24
Number of Repeaters………………………..……………..….……...24
Network ID……………………………………..………...…………...24
Wire Replacement…………………………………….………………….25-26
Digital Out 1 and Digital Out 2……………………….……………...25
Digital Def 1 and Digital Def 2……………………….………………25
Default Delay………………………………………………………….25
Digital Input Pull Up/Down…………………………….……...……..25
Installation………….…………………………………….……………………………….26-34
IO Slave……………………………………………..………………………...…..26-32
B+ …………………………………………… …………….……….……….26
1-5 Volt Sensor ……………………………..……………………………26-27
4-20 Milliamp Sensor …………………………………………… ….….27-28
1-5 Volt Sensor, Analog Input 3 or Analog Input 4…….…… …..…...28-30
Signal Levels and Accuracy……………………… ………...…......28
Signal Coupling for Analog Input 3 and Analog Input 4 ...…29-30
4-20 Milliamp Sensor, Analog Input 3 or Analog Input 4…… ……...30-31
Digital Input …………………………………….…………………..32
Digital Output …………………………… …..……………………………32
FGRIO Master ……………………………………..…… …………………….33-34
Rx, Tx, B+ ……………………………… …...…………………………..33
Analog Output ..….……………………………..………… ………………33
http://www.RSPSupply.com/p-20028-FreeWave-FGR2-IO-IOE-Radio-Enclosed-900-MHz-I/O-Slave-Radio.aspx
To Next Page
Loading...