Check before flight
1. Make sure that your transmitter is fully charged. Conduct a range test of your radio system per the
manufacturer’s specs.
2. Check all flying surfaces for correct direction of movement, correct amount of movement and for correct
centering, adjust as required.
3. Fully charge your flight batteries prior to flying.
4. Hand launch into the wind and land into the wind.
Flight Adjustment
1. On initial flight climb to about 75-100 feet and see if any trim is required. If the model rolls to the right, apply
some left aileron trim to level the wings. If the model dives, apply some up elevator trim, ect.
2. Landing should be made into the wind, reduce the throttle to just above idle and keep the nose level or a little
high allowing the airplane to sink toward the ground. Apply a little throttle as the model reaches an altitude of
a foot or so, this will slow the descent and aid in the flare to a smooth landing.
F9F Panther
Item No.:F1701 -9-
Spare parts for F9F
F9F landing gear
Item No.: F170106
64mm EDF
Item No.: F90210
2627-4300kv Brushless Motor
Item No.: F90131
F9F Fuselage
Item No.: F170104
F9F Tail Wing Set
Item No.: F170102
F9F Main wing Set
Item No.: F170103
To Next Page
Loading...
