I
5
D
C
A
B
H
F
A -
B -
C-
D-
E -
F -
G-
H-
I -
J -
K -
J
K
D
B
C
A
G
E
MIG-21MF FISHBED
Ite m No.:FJ210
(Ø
5x180mm
)
Carbon tube
PNP Assembly Instructions
1.Use the steel wire to pull the rudder servo cable through to the
battery compartment.
2. Use 4 screws to secure the rudder.
A. Vertical tail
B. Tail
fuselage
C. Servo wire
D. Screws (FA3x8 4pcs)
Rudder Installation
Nose cone, pitot tube, wing fence and drop tank pylons Installation
Nose cone
Antenna
Pitot tube part 1
Carbon tube
Pitot tube part 2
Plastic part 1
Plastic part 2
Wing fence
Fin
Pylon
Drop tank
(left/right)
Note:
1.
2.
After finishing the above steps, depending on the model of the control board, insert all servo cables to the control board.
Finally use 4 screws to secure the battery tray . (all servo cables run under the battery tray)
To Next Page
Loading...
