IMPORTANT: Do not use tools to tighten the
bowl and element.
8. Spin the bowl onto the onto the upper housing
by hand only.
9. Connect the water sensor and heater connectors
if equipped.
10. If equipped with a primer pump, prime the
fuel/water separator as follows.
10.1 Loosen the vent plug. Then operate the
primer pump until the fuel purges at the
vent plug.
10.2 Close the vent plug.
11. Start the engine and check for fuel leaks.
12. Shut down the engine and correct any fuel leaks.
Fuel 47
Recreational Vehicle Chassis Maintenance Manual, April 2018 47/5
To Next Page
Loading...
