40–02 Wheel Cleaning and
Polishing
Accuride® Machined and
Polished Aluminum Wheels
IMPORTANT: Do not scrub the wheels before
rinsing off particles with high-pressure water.
Rubbing debris against the surface of the wheel
can result in scratches. Synthetic cleaning pads
and wire brushes should not be used to clean
the wheels.
Do not use strong detergents, alkaline, or acidic
cleaners to clean Accuride aluminum wheels.
These solutions can etch the surface of the alu-
minum and leave dull areas. Do not use pol-
ishes or wax on Accuride ACCU-SHIELD alumi-
num wheels.
1. Rinse the wheel with high-pressure water to re-
move debris.
2. Use a 100% cotton cloth dipped in a mild soap
solution to help remove built up dirt and grease.
Dish soap or automotive car wash soap are rec-
ommended.
3. Rinse the remaining soap residue from the
wheel. Do not allow soap residue to dry on the
surface of the wheel.
4. Dry the wheel thoroughly with a 100% cotton
cloth.
5. Commercial bug/tar/grime cleaners may be used
to remove stuck-on particles from the wheel. It is
recommended that the cleaner be tested in an
inconspicuous area for discoloration before treat-
ing the wheel.
6. Do not use strong solvents to remove grease or
grime from the surface of the wheel. Damage to
the wheel surface finish might occur.
7. Do not use polishes or wax on ACCU-SHIELD
aluminum wheels. The finish will maintain the
bright and shiny surface for years to come with-
out the need for special polishes.
Wheels and Tires40
Recreational Vehicle Chassis Maintenance Manual, May 201140/2
To Next Page
Loading...
