8. Do not allow System to sit for extended lengths of time
without being used (10 days or more). If System must
be left unused for more than 10 days, drain all water from
the System and remove the Cartridge. Once you return,
re-install Cartridge and continue to use. In the event Sys-
tem is not used for 10 days or more, the System should
be flushed for fifteen minutes prior to use.
9. This System must be protected from freezing, failure to
do so may result in loss of performance, damage to the
parts and water leakage. If System is exposed to freez-
ing temperatures, drain water from Filter Housing and re-
move Cartridge.
10. Installation of this product must comply with all state and
local laws and regulations. Refer to your local agencies
for details.
11. The contaminants or other substances removed or reduced
by this product are not necessarily in all user’s water.
OPERATING SPECIfICATIONS
Model # FP3000
Installation Counter-top
EPA Establishment Number 63018-NV-001
Rated Capacity 480 gallons (3028 Liters)
Replacement Cartridge RC-30-FP
Rated Service flow 0.75 gal/min
Housing Construction Surgical Stainless Steel
High Impact ABS
Maximum Working Pressure 100 psig(689.5 kPa)
Minimum Working Pressure 30 psig(206.8 kPa)
Maximum Operating Temperature 100 Fº/ 38º C
Minimum Operating Temperature 32º F/ 0º C
2 FRESCAPURE™ FRESCAPURE™ 3
SET UP AND INSTALLATION
1. Open the shipping carton, remove the Drinking Water Sys-
tem and all items and place them on your kitchen counter.
2. Compare them with the parts shown in this manual to be
certain all items were included.
3. Remove the aerator from the end of your kitchen
faucet, if it has one.
4. Attach Diverter Valve directly onto your kitchen fau-
cet. Do not over-tighten.
5. If the threads to the Diverter Valve do not directly
attach to your kitchen faucet, use one of the three
Adapters provided.
6. Most kitchen faucets with external threads will
directly attach to the Diverter Valve. In some in-
stances the Diverter Valve may be smaller than
your kitchen faucet. In this case use the Adapter
with internal threads and attach it directly to your
kitchen faucet. Next, attach the Diverter Valve to
the Adapter.
7. If your kitchen faucet has internal threads, attach one
of the two Adapters with external threads directly to
your kitchen faucet. Next, attach the Diverter Valve to
the Adapter.
8. If your kitchen faucet does not have threads, measure
the inside diameter of the kitchen faucet and provide
this information to your Independent Royal Prestige
Representative or to the Royal Prestige Customer
Service Center (1-800-279-3373). Be sure to request an
expandable adapter.
REPLACEMENT PARTS DIRECTORY
fRESCAPURE™ 3000
ITEM PART NUMBER DESCRIPTION
1 1215-10-01 Cap Assembly
2 9-904-0066 Cartridge
3 1215-10-02 Housing Assembly
4 0531-50-05 3/8” Diverter Assembly
5 9-904-0023 3 piece Faucet Adapter Kit
To Next Page
Loading...