3
eng
To Disengage
Pull the metal lever outwards fully. Check the device
is disengaged by turning the seat unit. (refer to
illustration a1)
Base and Seat Assembly
(#01 swivel shaft, #03 base) Insert the swivel shaft
onto the base by pressing down firmly. (refer to
illustration a2)
(#02 swivel shaft housing) Insert the swivel shaft
housing all the way into the swivel shaft (make
sure the swivel resistor is disengaged). (refer to
illustration a3)
Insert the swivel shaft housing to the base by
aligning the ‘unlock’ icon marking on the base
to the indication line marked on the swivel shaft
housing. Turn until locked into position. You
will hear an audible click. In locked position the
indication icon line should point to the ‘lock’ icon.
(refer to illustration a4)
To disassemble, lift the slide button on side of
swivel shaft whilst turning to align the ‘unlock’
icon to indication line. Pull to remove.
Check the swivel shaft housing is securely locked
by lifting upwards. Press white button on top of
shaft to raise shaft. Engage swivel resistor.
(#04 seat unit) Insert the seat unit onto swivel
shaft making sure not to engage A & B triggers.
Check the seat unit is fully engaged by pressing
down several times on the seat unit. Tighten the
fastening cap counterclockwise. Then engage
the swivel resistor. (refer to illustration a5)
Swivel and Height Adjustment
To rotate the seat unit, disengage the swivel/
height resistor, and then turn the seat unit
sideways to desired position. (refer to illustration
a6)
To adjust the height down, lift both A & B triggers
simultaneously, and push down firmly to the
desired height position. To adjust the height
up, lift both A & B triggers simultaneously and
release at different intervals to adjust to the
desired position. (refer to illustration a7)
IMPORTANT!
Ensure the seat unit is firmly inserted onto the
swivel shaft before use. Check the seat unit
is assembled properly by trying the height
adjustment function, following the instructions
in this user guide. If the height adjustment fails
to work, this means the seat unit is not properly
assembled, please re-try and press seat unit
downwards on the swivel shaft firmly in order
to properly engage the height adjustment
mechanisms.
Lift and Glide – Easy Glide Wheels
To move the baby chair across the floor, the seat
unit must be front facing and in the lowest height
position. To rotate the seat, first disengage the
swivel/height resistor, then rotate the seat to
front facing position. (Refer to illustration a8)
To Next Page
Loading...