4
eng
Keep the swivel/height resistor disengaged
and lower the seat height by lifting both A &
B triggers simultaneously, and pushing down
firmly to the lowest height position. (refer to
illustration a9)
It is easiest to move the baby chair if the seat is
in the reclined cradle position. To adjust the seat
unit to the reclined cradle position, pull on the
handle on the rear of the seat unit, then recline
the seat to the lowest position and release the
handle. You will hear an audible click. (refer to
illustration a10)
Tilt the baby chair forward by lifting in the handle
area located on the rear of the seat unit, and
then glide the high chair across floor using the
castor wheels, which are located under the front
end of the base. (refer to illustration a11)
WARNINGS:
• Continue to assemble the baby chair
according to the configuration suitable
for your child. Follow the corresponding
instructions carefully.
• A child’s safety is your responsibility.
WARNINGS:
• Prevent serious injury or death from falls or
sliding out.
• Always secure child in the restraint.
• Never leave child unattended.
Section B: Reclined Cradle Mode
– suitable for 0-6 months (refer to
illustrations section b)
WARNINGS:
• Do not use the reclined cradle once your
child can sit unaided.
• Reclined cradle mode is intended for children
with a maximum weight of 9kg.
• Never leave the child unattended when the
baby chair is in reclined cradle mode.
• The child should be secured in the baby
chair at all times by the 5-point safety
harness in reclined cradle mode.
• It is dangerous to put this reclined cradle on
an elevated surface.
• Keep the product away from open fire,
heaters and other sources of strong heat.
• Do not use the product unless all
components are correctly fitted and
adjusted.
• Make sure harness is correctly fitted before
use.
• This reclined cradle is not intended for
prolonged periods of sleeping.
• It is dangerous to put this baby chair on an
elevated surface.
• This reclined cradle does not replace a cot or
a bed. Should your child need to sleep, then
your child should be placed in a suitable cot
or bed.
• Do not use accessories or replacement
parts other than those approved by the
manufacturer.
To Next Page
Loading...