The appliance is supplied with the following components as standard:
1 x Vacuum Sealer
1 x Vacuum Tube
20 x Vacuum Bags (200x300 mm)
Check the package for completeness and for signs of visible damage.
If the consignment is incomplete or damaged due to defective packaging or carriage, please contact us.
Note:
Scope of Delivery
Installation Requirements
Electrical Connection
Vac Slot Cleaning Indicator Light
DRY Button
Opening
SEAL Button
/EXTERNAL VACUUM Button
MOIST Button
Circle Progress Bar
Removable Drip Tray
Power Cord Storage Case
For safe and trouble-free operation of the device, the set-up location must fulfill the following requirements:
Before connecting the device, compare the connection data (voltage and frequency) on the type plate
with those of your power supply. This data must match to prevent damage to the device.
Make sure that the power cord is undamaged and does not run over hot surfaces and/or sharp edges.
Make sure that the power cord is not taut or bent.
Do not let the power cable hang over edges (trip wire effect).
Insert the plug into the mains power socket.
When setting it up, place the appliance on a firm, flat and horizontal surface.
Do not place the device in a hot, wet or extremely damp environment or in the vicinity of flammable
materials.
The mains power socket must be easily accessible, so that the power cable can be easily disconnected in
the event of an emergency.
If possible, keep the original packaging during the warranty period so that the device can be properly
packed for return in the event of a warranty claim.
21
To Next Page
Loading...