No. Problems
Vacuum bag
sealing is incomplete,
there is an opening
3
Vacuum bag
sealing melt
through
4
Causes
1. There are foreign bodies in the
sealing work area
2. The opening of the vacuum bag
is not even, folded or overlapped,
so it is not enough to put into the
machine
1. Use of the bag non-vacuum
packaging machine special
vacuum bag (not high tempera-
ture resistance)
2. Choose "wet pumping mode"
when sealing dry substance
3. The adhesive tape on the
surface of the heating component
of the machine is damaged (the
brown adhesive tape is located
above the dripping box of the
machine, and the part that drops
and touches the vacuum bag
when vacuumizing).
1. Select a vacuum bag suitable
for the vacuum packaging
machine
2. Select the "DRY" or "MOIST"
mode according to the substance
type
3. Keep the sealing area
clean/tape intact (the damaged
should be replaced)
The SEAL key
is blinking
continuously.
Other functions
cannot be used
5
The machine entered the set state
of overheating protection, at this
time the use of other functions is
restricted
After about 15 minutes of the
machine standing, the natural
cooling machine can be restored
to use after the aperture of the
button panel is lit
The "EXTERNAL
VAC U U M "
button continues
to blink
6
The machine entered the
"EXTERNAL VACUUM" continuous
air pumping protection state, at
this time, other functions are
restricted
After about 15 minutes of the
machine standing, the natural
cooling machine can be restored
to use after the aperture of the
button panel is lit
1. Clean/keep the surface of parts
in the machine sealing working
area clean and without damage
2. Keep the opening of the
vacuum bag flat, press it tightly
and put it flat into the entrance of
the machine, and push it to the
end to contact the baffle of the
drip box (about 50mm). If the
vacuum bag is used, it is better to
put the opening of the drip box
downward into the machine
instead of sheet bag
33
To Next Page
Loading...