Self feeding hopper slow juicer SJ-029C
USING FOR FIRST TIME
1.
Remove all packaging materials, plastic bags and labels.
2.
Make sure the electricity supply is 100-120V~60Hz.
3.
Clean the feeding tube cover/squeezing auger/juice cup/pulp cup/ juicing bowl/ pusher
with soapy water. Then rinse and dry thoroughly.
NOTE : DO NOT IMMERSE THE POWER BASE UNIT IN WATER.
4.
Assemble the parts per the instruction in the assembling method section.
5.
Connect the power cord to the power source.
The unit is ready to use now.
ASSEMBLING METHOD
Please make sure the unit is not plugged and the switch is turned to “OFF” setting
prior to assembling the machine.
1.
Position the squeezing bowl on the Power base aligning the position of the spouts
and the axle. (Fig 1)
2.
Push the squeezing auger firmly into the center of the bowl, making sure that it
touches down the bottom, or else the cover cannot be closed. (Fig 2)
3.
Position the chute on the bowl to align the ▲ to the “ ” and twist it clockwise
until it clicks the safety lock. Please make sure that the arrow ▲ on “ ” the
cover aligns with the Lock graphic on the Bowl. (Fig 3)
4.
Place the juice container and the pulp container under the relevant spouts. (Fig4)
Fig 1
Fig 2 Fig 3 Fig 4
To Next Page
Loading...