Friedrich AG - User Manual

To Next Page

INSTALLATION INSTRUCTIONS

ARCHITECTURAL GRILLE MODEL AG

These instructions cover the installation on an Architectural Grille, Model AG, into a WSC model solid-side sleeve.

The Architectural Grille must be installed just prior to the installation of the air conditioner chassis.

The contents of the package are:

1. AG Architectural Grille

2. Brackets, 2 each

3. Fiber strap

4. Screws (10 each)

5. Instructions

Tools required for installation: A ﬂ at-blade screwdriver or 1/4" hex. nut driver.

STEP 1. WSC sleeve should have been installed as speciﬁ ed in the Sleeve Installation Instructions. Remove

the front closure panel, louvered metal grille and back weather panel in the sleeve. Should the air

conditioner chassis be in the sleeve, remove the chassis and the louvered metal grille using proper

procedures.

STEP 2. Install the mounting brackets. The brackets are not interchangeable. See Figure 1 below to identify

the correct bracket. Position the left bracket on the left ﬂ ange inside of the WSC sleeve, towards the

back, so that the three holes on the bracket line up with the holes on the sleeve ﬂ ange (same holes

used to mount the louvered grille just removed). Mount with the three screws provided. Repeat the

procedure to install the right side bracket. See Figure 1.

FIGURE 1

617-408-01 (7-05)

Need help?

Do you have a question about the Friedrich AG and is the answer not in the manual?

Summary

Prepare the WSC sleeve by removing front closure panel, louvered grille, and back weather panel. Remove chassis if present.

Install left and right mounting brackets onto WSC sleeve flanges using screws, aligning with existing holes.

Install grille into sleeve with louvers down. Secure with screws, then install the air conditioner chassis.

General

Brand	Friedrich
Model	AG
Category	Air Conditioner Accessories
Language	English