Check Filter: Your ‘Check Filter’ LED will
light up after approximately 250 hours of
operation, notifying you that your filter needs
to be cleaned.
Filter Reset: press ‘Temp ∨∧’ together to
turn off ‘Check Filter’ light.
*Timer Clear: On remote control, ‘Timer Clear’ button
will cancel the timer setting
8
2
1
3
4
5
6
7
8
3
2
5
6
7
*Filter Reset must be done from unit control
panel, not remote control
Push the ‘Mode’ button to rotate between
MoneySaver → Cool → Fan Only → Heat.
MoneySaver: The fan will stop when the compressor
stops cooling. The fan will turn on approximately every
3 minutes to sample to room air and determine if more
cooling is needed.
MoneySaver has it’s own button on your remote control
Cool: fan runs continually for normal cooling operation
Fan Only: Fan-only operation
Heat: fan runs continually for normal heat operation
4. CHECK FILTER & FILTER RESET
6. OPERATION MODE SELECTOR
To Next Page
Loading...
